I had an issue with my 4 year old garage door being slightly crooked leaving a small crack on one side which let debris and a small draft through.
Garage door closing slightly crooked.
Push the door push the door back to adjust the door and get the center aligned again.
The most likely culprit when your garage door goes crooked are the cables.
Hassle would be an understatement for a crooked garage door.
Here are three possibilities.
A broken spring typically will make the door very hard to lift rather than causing the door to stick halfway.
If the opener is adjusted properly the garage door will move up and down in an even motion.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
Your garage door has two overhead springs some doors have the springs on the side called extension springs that are responsible for opening and closing the door.
By pushing the door back into position you should have made the vertical track straighten.
Once the spring is free of tension remove from its track hanger.
Warping of the door will also cause it to run crooked and stick in the tracks.
To avoid injury make sure the spring is completely free of tension before removing.
If the door was closing too quickly move the spring to the next higher hole on the bracket.
One of the most likely culprits when you have a crooked garage door is a broken torsion spring.
Garage door springs support most of the weight of the door when it s opening and closing.
I actually had another garage door repairman five star garage come out 2 months ago who tried to level it by spending just 5 minutes loosening one side.
This will cause the unit to stick.
3move the spring within the track hanger.
It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw.
So why is your portland garage door crooked.
Pulling the door up and down is a garage door opener.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
If it was opening too quickly move it to the next lower hole.
Without proper adjustment however the unit may run along the tracks unevenly.