Gap Between Edge Of Roof And Edge Of Gutter

Once up the ladder i was able to see the new guttering fascia installation done about 18 months old close up for the first time and i m worried about it.

Gap between edge of roof and edge of gutter.

What are some solutions to cover the gap between the roof deck and the fascia board. Drip edge flashing directs roof runoff away from the roof fascia and edge and into gutters or at least not down the fascia board if no gutters are installed and it is recommended by roofing standards manufacturers and experts. If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap. I have gutters all the way around shingles overhang 1 1 5 get good flow to gutters.

My issue since not on contract and i did not check life lesson. I don t have gap all around just in some areas. I recently had roof replaced and did not have drip edge installed. Home centers sell rolls of 6 in.

Once the apron s in place fasten it with sheet metal screws. Other than being old and rusty they are working fine based on my obser. Does not address our recommended best practice of drainage gap for drip edge installation on roofs. The gutters are getting old and i want to replace all.

Looking right down the line of the guttering the gap between the end of the last roof tile and the outer edge of the guttering varies from around an inch and half to in some cases millimetres. The 3 would be the distance measured from the drip edge the point at which the water falls from the roof to the top of the gutter. For gutters to work properly they must be properly sloped toward the downspouts and the roof must have a drip edge that clears the sides of the gutters closest to the house. Since the gutters have to slope down towards the downspout this distance will increase as you get closer to the downspout.

I have a 30 year old house which i have owned for the last five years. If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter.