Gap Between Door Threshold And Floor

Figure 2 floor relative to entry door.

Gap between door threshold and floor.

Flush transition moldings are. This allows for proper air exchange between rooms. Hardwood floor thresholds are strips of wood that cover a gap between the floor and the edge of a door sill making the transition between the two areas even which prevents tripping. If it s a tall threshold that is often required by hurricane code and the quarter round will help.

The door gap to the floor should be 5 8 to 3 4 inch. This was part of a major renovation that involved replacing all the trim and repairing damaged plaster. Most entry door frames have a piece of lumber below the door and combined with the metal threshold will raise the base of the door off the concrete or wood sub floor by approximately 1 1 4 inches as shown in figure 2. Cut a wood shim to fill the gap between the bottom of the molding and the subfloor.

This number is regardless of flooring. In some cases weight may have to be applied to the molding to keep it in contact with the adhesive until it cures. I just had engineered wood floor installed glue down method and there is a gap between the threshold of the front door and the wood planks in the house. However the front door transition piece didn t have a lip i e it wasn t a t molding shape that the planks could disappear into so i ended up a.

Between the door and the threshold or the threshold and the floor. If there s a gap under your door casing and also a gap between two rooms under a door where two different installations of laminate flooring join you can install t molding to hide both gaps. The areas around the doors were stripped down to the studs and headers but the hardwood floors were left in place. It should be measured from the floor surface to the bottom of the door.

On the inside of the entry door finished flooring is laid on the concrete or wood sub. Bond the shim to the subfloor and then bond the molding to shim. Gap between floor edge and front door transition i laid down a laminate floor and left the required gap along all edges including where the floor meets the transition piece to our front door. The photo seems to show a gap between the threshold and the door itself which makes no sense and the threshold won t help.

Gap between threshold and floor. Installing flush transitions with a floating floor.